Posted by James22 on August 20, 2012 at 11:21:53 from (207.179.239.77):
In Reply to: Chopping silage posted by Sparktrician on August 20, 2012 at 10:05:19:
I've heard you will get about 80% of the rows that are run over. Anything a tire runs over you will not get. We were always too thrifty to waste corn, so had to cut two rows down and back by hand. Also the ends and enough of the corners that the chopper could get around without mashing the corn down. Manually fed the cut corn into the chopper as it traveled thru the next two rows. Immediately after starting your bundle thru the chopper you quickly cycled to the adjacent row, went to the front and readied another bundle to be fed. Required at least three men but four would allow a short "breather". You had to move quicker than a fast walk to keep up with the chopper and only three men. Chopper remained stationary as we fed corn bundles stacked in the corners. Don't believe OSHA would approve. Loved filling the silo, but hated those two very physical jobs.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An AC Model M Crawler - by Anthony West. Neil Atkins is a man in his late thirties, a mild and patient character who talks fondly of his farming heritage. He farms around a hundred and fifty acres of arable land, in a village called Southam, located just outside Leamington Spa in Warwickshire. The soil is a rich dark brown and is well looked after. unlike some areas in the midlands it is also fairly flat, broken only by hedgerows and the occasional valley and brook. A copse of wildbreaking silver birch and oak trees surround the top si
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
