Posted by Notjustair on August 20, 2012 at 20:02:04 from (174.229.66.30):
In Reply to: Chopping silage posted by Sparktrician on August 20, 2012 at 10:05:19:
We always made sedan sileage and put it in a pit trench. Grandpa was a tightwad. We put it right on the dirt and didn't cover it. We had about 6 inches at the top that spoiled but it got fed anyway. He always thought a tractor would waste so we put it in the back of the pickup with an ensilage fork (by hand). Then shoveled it into the bunks. I can only remember using the loader tractor during heavy snows and we still forked it into the loader by hand. He did that after I was gone until he turned 80.
I do remember hauling water in 5 gallon buckets to put out fires on the pit many times. Seemed to always be about 2 am when we piled into the 1949 chev pickup to haul out water.
I still love the smell of sileage to this day. Those are some of my best memories.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
