Posted by Tinkerer05 on August 29, 2012 at 11:24:14 from (71.76.160.92):
I have a two wire well pump at approx. 385ft. There is a Pressure Tank and a Pressure Switch (40/60).
With power off, I measure: • 4.8 ohms between the two wires going to the pump (manufacturer’s winding resistance spec says 3.2 – 3.8 ohms, plus cable resistance from the well head to the pump • On the pump, open circuit between each wire and ground
With power on, at the well head I measure: • 235 VAC • 6.2 Amps on each of the wires (manufacturer’s spec for the current: full load - 6.8 Amps, Max load – 8 Amps)
My problem is that I am not getting any water coming out of the well, after 10 years of good service. Since the readings all seem to be normal (I think) for the pump, it seems that the only conclusion I can reach is that the well has gone dry. Are there any other possibilities?
What should the psi be in the Pressure Tank with power off? I measure 10 psi. Is that reasonable?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.