Posted by Boo Boo on September 28, 2012 at 16:46:41 from (96.53.210.246):
In Reply to: PICTURES posted by downsouth on September 28, 2012 at 15:04:46:
In the mid to late 90's just outside of Edmonton, a brand new Cat D10 was written off when it hit a railway bridge while being delivered to a local coal mine. It was actually wedged almost vertical under the bridge. It was front page on the Edmonton Sun paper. Apparently the mine had purchased 4 or 5 D10's and this was the last one to deliver. The ripper shank was put in upside down for transport but somehow they forgot to lower it on the last machine and it hit the bridge wedging the Cat under it with the trailer squished flat on the ground. The fifth wheel was ripped completely off the truck and the driver was in shock and taken to hospital. I think they said he was doing close to 50 MPH. The bridge didn't look like it received too much damage in the picture. There's been a few excavators hitting bridges too.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
