Posted by jm. on October 04, 2012 at 15:51:25 from (99.196.0.56):
In Reply to: water in crank case posted by jerry 4 on October 04, 2012 at 09:58:50:
Atthe risk of all the other posters laughing here goes 50 years of experience.. NEW oil WILL mix with water and turn white or milky. Go to where someone runs large disel fleet of semi tractor trucks. Take a clean containe and as they drain a truck catch you a coupel gallons. Drain you mower fill to the required mark with this USED OIL.. run you engine 20 minutes or so. Shut it off and let it set with the drain in the lowest place. In the morning remove the drain and out will come pure seperated water or moisture. THEN you can drain the used oil and replace with new. Have uses this procedure on large machines for years. USED OIL from desiels will just not absorb water, will help flush it all out.. Let us know the results, think you will be suprised how easy it was.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
