Posted by blunosr on October 13, 2012 at 18:15:08 from (66.183.235.147):
In Reply to: Stair Stringer Rise posted by John in La on October 13, 2012 at 16:05:56:
Yup, make 'em all the same height (rise). My recollection says the magic number is 66. Rise x run, in inches, should equal 66. I always try to use as close as possible to 7 1/4" rise, and 9" run. Anything greater than 7 1/2" rise will feel steep. Also, be sure to put your step boards on so they will bow downwards (not cup upwards). It seems counter-intuitive, but the heartwood should be at the upper side of the tread. They cup opposite the growth rings. That's because the rings shrink the same amount laterally, and you have a much longer ring on the outside of the tree, so it shrinks more.
I seem to recall that 66 is also the height, in inches, from the closest tread to any overhead obstruction.
Good luck with them, stair building is the mark of a true carpenter.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
