Posted by dave2 on October 14, 2012 at 13:51:01 from (79.240.142.116):
Hey folks,
Have a paddock area of about 1000 sq ft with concrete grass pavers on top of a couple inches of gravel. Place slopes slightly to the ditch 15 ft or so away. Has one spot about 6x6 or so feet that gets wet and a little soupy at just the hint of any rain and stays that way for a few days after it stops. Tree huggers won't allow any major work in the area. Looking at the picture, I was thinking to just dig a trench ad the edge the length of the wet area and 2ft deep with a leg going to the road ditch with gravel, leach field pipe, and gravel on top then the sod. Ditch would be about 6ft from the wet area. Think it would take care of the problem without pulling out the pavers? Not so much being lazy, just have to do the digging and get it covered back up quick before anyone figures out what's happening.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
