I have both a binder and shreader setting here in the barn, both usuable but not used since 1959. Only my binder is a John Deere and the shreader is a New Idea. It was always set to run the bundle carier all the time tho and with the bundle carrier you on the next pass were not running over the bundles like without it unless you picked them up every round and that was not likely. You cut as much as you wanted and then went back out and set the bundles in a shock. For years when it was time to get in to the shreader just went out with the buckrake (It was a 1929 Buick 4 door sedan with the back doors removed and the top cut off at the back side of the rear doors, would walk a load out of the field in high gear) that was also used for putting in the loose hay and would put 4 shocks on the rake at a time. Dad had made a conveyor to put the bundles on standing on the ground to take them up to the feed table of the shreader without lifting them over waist high.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
