Posted by Ultradog MN on October 18, 2012 at 10:26:45 from (184.100.106.5):
In Reply to: O/T Coyotes posted by greenmachineman on October 18, 2012 at 05:48:21:
Growing up in central Minnesota we never heard of a coyote in the area. Then about 15 years ago I hit one with my pickup - just tapped his tail as I sped by about 55. Then we started hearing them at night once in a while camping up at my land. 2 years ago while hunting I shot a big doe. I waited for a while and then went to check if I could find her. Found her not far away but then my buddy shot so I left her there and went to help him recover his deer. We got back to my deer about an hour later and a coyote had already started eating into my doe. He had opened her up at the ribs where the bullet exited and had eaten all around her ribs and was just getting into the tenderloin. We still kept the doe and cut that part away but now we don't leave them lay for very long as they are opportunists and don't wait around if there is a meal handy.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
