Posted by Indiana Ken on November 06, 2012 at 06:12:43 from (66.249.234.243):
In Reply to: True Horse Power posted by David G on November 05, 2012 at 21:40:15:
Horsepower is a calculated value: RPM and torque are measured on a dyno and horsepower is calculated from the following formual:
HP = (RPM x Torque) / 5252
HP is a measure of the amount of work an engine can do per unit time and holds true regardless of the combination of RPM and torque. Note that for a low speed engine the torque must be high and conversersely for a low torque engine the RPM must be high for equal HP.
Engine torque is a function displacement and cylinder pressure. For a given engine displacement, increasing cylinder pressure will result in an increase in torque. The average cylinder pressure for any engine can be estimated by the folllowing formula:
MEP = (HP x 792,000) / (Displacement x RPM) MEP = Mean Effective Pressure
Increasing engine displacement will result in an increase in engine torque. The increase in displacement can be from boring or stroking - the torque increase will be similar.
For low speed applications a longer stroke is typically used since large valves are not required to flow air at high RPM. Also, longer stroke engines have smaller pistons so the torque comes with a lower rod and crank bearing load. In this case low speed is a mis-nomer since piston speed can be very high in these engines.
If very high HP is the goal then the engine is typically designed with a larger bore to allow room for large valves. The large valves allow the engine to breathe at high RPM and the shorter stroke reduces piston speed.
Long stroke, short stroke, high torque, low torque, high speed, low speed; HP is HP. However, for this to be true the engine needs to be coupled to the load with the appropriate gearing.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
