Posted by Jared in wi on November 08, 2012 at 15:45:28 from (71.95.95.108):
In Reply to: 6420 code posted by pt80 on November 07, 2012 at 20:25:30:
With the key off disconnect the wire from the speed sender located on the timing gear cover in front of the injection pump on the LH side of the tractor. It will have a large hex head on it for removing and installing it. If there is oil in the connector, that is a good indication that the sender is bad. Remove the sender and check to see if there is a metal cap on the end that goes in side the engine. If there is no cap I would suggest replacing it regardless.
What happens in that the oil enters the sender and causes faulty readings or no readings. The new sender if you install it will have a metal cap on the end that goes in to the engine to prevent oil from entering the sender. Replace seder and o-ring.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
