Posted by Don-Wi on November 10, 2012 at 19:40:24 from (75.249.117.64):
In Reply to: NH 782 harvester posted by JayinNY on November 10, 2012 at 19:29:53:
I think it depends on how big the windrow is. We've got it's big brother the 892, and this was our first season with it. We only have a 100 HP tractor on the front which is much smaller than it can handle, so it's a matter of ground speed to work the tractor. Is it 540 or 1000? I would think that if the knives are set up properly you should have no problems with even 80 on the front, or less with a smaller windrow. From what I have experienced so far with our 892, they're pretty easy running machines.
The benefit of a smaller than capacity tractor, is it's very hard to plug it up. The tractor bogs down long before you get close to plugging.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
