honestly, i would be surprised if it ran both.maybe ,look at the rating plates on your appliances. if they have running loads listed in amps instead of watts,simply multi ply the amps X voltage (120) to get watts. keep in mind that the inverter itself will be a load also. be very certain to keep polarity correct, add disconnects as needed because you most likely dont want power feeding back into your inverter. the main problem with these type setups is they draw power even when furnace or whatever is off,through the inverter.without some type of maintainer running constantly to run inverter and charge battery,the battery will go dead over time. my opinion of course, but if this system was just for occasional/standby use,a small genset would serve you better. IF you were designing a system for off grid use using inverters and things,you would be much better served with a straight 12 volt system,appliances etc. that way you wouldnt have the constant loads you would have inverting/converting power.anothe roption would be to have a small 12 refridge,and move your food in there during power outages.furnace could something like propane stove or the like that needs no external power.my opinion of course,but you normally do not use a inverter as a power source where power to run a alternative is available .your burning gas to run a alternator that needs power to just turn on,then your hooking it to a inverter that sometimes uses more enrgy than it makes,then your running the most ineffecient systems off that.triple waste of power.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
