This came up at the right time for me. I'm going to blow fiberglass in the new shop ceiling on Saturday and it will be 16". Lumber yard claims the power company will help on the cost if it's 16". I don't think they will help out on anything more than that.
Buick mentioned air leaks. This is more true than most of us realize. My old shop is 30x32 with a 13 foot ceiling and when I built it I went to excesses to make sure it was tight. It has six inches of fiberglass in the walls and 12" of cullulose in the ceiling. Back when I was burning wood I had gas heat also but it was set at just above freezing to keep the shop from freezing after the fire died out at night. The propane tank was a little 100 gallon job and one tank lasted till mid-march, and after that is wasn't needed till the next winter. One summer the big door got cracked (I know how it happened but don't ask) and I didn't fix it. Crack was maybe 12" long and spread possibly 1/8" at most maybe less. That next winter the tank ran out in February. Couldn't figure it out till I happened to be laying on the floor by the door and felt the slight breeze coming from the crack. So that crack wasted 35 gallons of propane for me that winter. A quick piece of duct tape over the crack would have saved me that much fuel.
Talking about blown insulation. That 12" of cellulose that was blown in the old shop attic in 1982 is now 6" of paper mache. This building has an uninsulated steel roof with a 4' ridge vent and the condensation drip over the years wrecked the insulation. The attic should have had better venting and maybe the steel should have been insulated.Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
