Posted by Zachary Hoyt on December 21, 2012 at 09:02:03 from (173.84.189.49):
I have developed a leak on the top of the carburetor on my Farmall 300 where the gas line adapter screws into the casting. The casting is cracked in two places (at 11 and 3 o'clock) to the full depth of the threads where the brass looking fitting screws in. I found this out when I tried to tighten the fitting and found that it would not tighten. The bowl of the carb was cracked from water freezing in it before I got the tractor and a very kind forum member sent me a good bowl. The carb is in good shape otherwise and I would like to know if there is any kind of hardening sealer that I can use to repair the casting and secure the adapter that will be gas proof. I know epoxy and JB weld are possible, but I am not sure how the gas would affect them or if there is something else I should try. There is also a mystery screw in a passage that comes into the area where the screen would be if I had one at a 45 degree angle. It is not adjustable when the carb is mounted on the tractor because the head is aimed back at the block. I did not see it mentioned in the manual and I am wondering if I will do any harm by blocking the passage which will probably happen if I am putting any kind of goop in there. Any advice will be much appreciated. Zach
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.