Posted by PJH on December 23, 2012 at 16:51:00 from (50.40.251.129):
I didn't want to hijack Royce's post below. He made some fine looking fudge - and I bet it tastes as good as it looks! My wife made a couple of boxes of fudge for the mailman and his substitute carrier, and I got the scraps 8~) (See the pic) I thought you folks might like the recipe. Paul
------------------------------------------------- Easy Microwave Fudge (Adjust times for your microwave)
Ingredients: 1 - 11 ˝ oz. package of chocolate chips
1 - 16 oz. can of creamy chocolate cake frosting
Put the chocolate chips in a microwavable dish and microwave for 90 seconds or until creamy.
Remove the melted chips and stir in the can of cake frosting.
Microwave for another 90 seconds.
Remove and add nuts, if desired.
Stir well and pour into an 8“ X 8” pan that‘s been lightly sprayed with Pam.
Cool well before cutting.
A couple of tips: Place a piece of wax paper, lightly sprayed with Pam, in the bottom of your 8 X 8 pan before pouring in the mixture. Cool it in the fridge. The fudge should lift right out of the pan when cool. Cut it on a cutting board, using a pizza cutter (roller).
For peanut butter fudge, substitute peanut butter chips and white cake frosting.
For white fudge, substitute white chips and cream cheese frosting. Watch closely when microwaving the white ingredients. They’re easy to scorch. -------------------------------------------------
My favorite is semi sweet chips and dark chocolate frosting, but I’m kinda partial to the white fudge, too.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
