Posted by ralph wilton on December 31, 2012 at 07:37:57 from (64.127.82.36):
In Reply to: used oil heater posted by Ralphwd45 on December 30, 2012 at 19:58:54:
we got some plans off the net years ago to make a oil injecting nozzle you take a 1/4 copper line insert a large torch tip cleaner and smash it down then insert this in a 3/8 steel line so it almost sticking out the end intall a tee and have the oil run down the 3/8 steel pipe with a bal valve to control the flow then hook regulated shop air to the copper line run about 30psi of air in it this will ake like a fuel injector and atomize the oil we have heated our shop for 10 years this way cost 13 dollars to build and no filters to plug or anything to clean the barrel of oil is mounted behind the stove aways we use about 15 gallons a day when its real cold
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
