Posted by Diydave on January 04, 2013 at 16:14:37 from (96.244.154.80):
In Reply to: Can this be fixed? posted by casedc3 on January 04, 2013 at 14:46:17:
I would clean the paint off the carb, and mike the diameter of the cracked area. Then I would machine a sleeve, a few thousandths smaller than the mike measurement average, for the ID. I'd make it about 1/8-3/16" thick on the wall. Then grind any deformation near the crack, and heat the sleeve cherry red, install, and let cool. Put the fitting in with pipe dope, or permatex #2. It's really not that high of a pressure, just gravity fed fuel, maybe 4-5 psi. My guess is the fitting got tightened too much, to line up the line, don't repeat that.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
