Rocko before you do anything make sure it is WATER??? A high pressure internal leak can cause the oil to foam and look milky.
Take a glass quart jar.(really any glass jar with some depth to it. You want glass to be able to see through it) Fill it 3/4 full. Then you need to heat the oil up. I put a pan of water on the cook stove. Then set the jar of oil in the pan. Let the stove heat the water an that will heat the oil. It is much safer doing it this way. Less chance of a fire. If you just heat the glass you may break the jar and have fire start.
When the foamy/milky oil is warm it will separate out if it is water. If it is justed foamy the heat will purge the air bubbles out and it will clear up an look normal.
Doing this is a cheap way to save yourself the cost of replacing the oil to find you have hydraulic problem not a water issue. This is especially true since you have a loader on the tractor. A loader works the hydraulic system more. Plus if you have a valve plumbed into the SCV to run the loader, it is common for those valves to foam the oil. They usually are just simple spool valves. They depend on the fit in the bore to seal around the spool. As they wear they can leak internally and cause the foaming I am talking about.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
