I did a clutch job on my '02 Chevy Silverado last fall. After I removed the trans and flywheel, I found the pilot bushing was pressed into the crank too far. I even took a picture of it. I bought it w/ 47k miles on it and I knew it hadn't been messed with since then. The isolation pad on top of the trans where the gear shift enters the cab was also cut, like someone had taken a saw to it in order to get it out.
Suspicious, I called the dealer where I bought it and found out that the clutch/trans had been replaced under warranty at 8k miles. I pulled the pilot out with a jig I built out of a piece of scrap and a carriage bolt. Worked bettern than other "shade-tree mechanic" methods.
I installed a new pilot bearing and set it to spec which was almost flush with the face of the crank. However, I remember thinking that the old one was so far back, I could almost have put the 2nd one in w/o removing the old one. Not that I considered doing it. And I didn't measure anything to see if 2 would actually fit. But my point is that it might be possible to do on some vehicles . This is the only trans I've done, so I'm not expert. If I can find the pic, I'll post it.
The concern I had with mine was if the front of the trans shaft was unsupported or had little support. Witout doing a stack-up, there'd be no way of knowing when everything was assembled. Maybe someone could chime in that's done a clutch and FORGOT to put a new bearing in. Will it run? Vibrate? Tear itself to pieces? Just chug along and cause wear on the rear bearing?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A City Guy's First Tractor - by Fred Hambrecht. After living in apartments in Atlanta for more years than I care to remember, the wife and I decided to move to the country. Humming "Green Acres is the place for me..." we purchased a 29 acre tract about 60 miles south of Atlanta. Next came the house, I could talk about that ordeal for another two weeks... But, I want to talk about my tractor! We didn't even own a lawnmower, and all of a sudden we had enough grass to feed all the starving children of the bovine world. Naturally, I talked
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
