Posted by andy r on February 03, 2013 at 16:05:34 from (75.91.149.15):
I have a 24 foot by 20 foot tool/storage shed that I need to have more light in. I have bought 8 used fluorescent fixures. Each has 3 - 4' bulbs. They are the smaller bulbs and will light below 32 degrees. Should I run the fixtures longway, spaced equally apart (about 1 1/2 foot between each) going with the long part of the building? Maybe the first row five foot from one side wall and the other row five foot from the other side wall - that would leave about eight feet between each row of lights. What about height off of the ground? The cross braces holding the building together at the top plate are about 8 1/2 feet off of the floor. I was figuring on running 2" by 4"s across and screwing the lights to it. Didn't think I should put the lights above the cross bracing due to shadows, but I could. Any other ideas about using these light fixtures would be beneficial. Thank you.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Brief History of Tractors in Australia - by Bob Kavanagh. After Captain Cook's exploration of the east coast in 1770 the British Government decided to establish a penal colony in Australia. The first fleet arrived in 1788 and consisted mainly of convicts who were poorly equipped and new little of farming techniques. The colony remained far from self-supporting and it was not until the early 1800's that things started to improve. Free settlers started to arrive, they followed the explorers across the mountains and where land was suitable set up farms. T
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.