Well Kent I have done more of these than I could begin to count.
You are correct in that the clutch plate does not run directly on the flywheel. The wear/separator (#10 & #3 ) plates do run on the drive pins(#9). The tractor in question was ran long past the time it should have be rebuilt. The pins are shot. The separator plates and the clutch plates are shot as well. I do not see how they could still be flat when they where ran this long while slipping. This mechanic is just trying to only put new clutch disks back in it, nothing else.
Now what I meant by having the flywheel machined. ( I did use the wrong term when I wrote re-surfaced. Sorry about that if it caused confusion. I often think faster than I can type or vise versa) We do have the total stand height machined down on the early 30 and 40 series JD flywheels. There was a service bulletin in the early 1980s on this. The total dimension is about .030 shorter than it would have been from the factory. Waterloo factory DTAC told us to do this years ago to increase the clamping pressure put on the clutch plates. This will make the clutch plates last longer.
The local machine shop has the exact dimension it needs to be. They have been doing them for years.
The point of the post was that the cheaper mechanic is going to cut corners and do an inferior job.
Thanks for pointing out my decription error. Other may have been confused as well. I often have trouble getting my thoughts on paper so to speak.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
