Like another reply suggests, the one on the right is protruding enough to weld to. That being the case, no more than it is sticking out, it would be easier to weld a washer to it first, and then a nut to the washer. Apply a penetrant of some type to it as it cools and once completely cool it will usually back out.
For the one broken off below the surface, what I do to find center is to use a transfer type center punch where the shank is the same size as the bolt hole. Even on a shallow hole it's not that hard to get one the right size close enough to center to work. If you don't have one of those punches, a standard center punch and a good eye will work just as good. The main thing is start with something like a 1/8 bit to insure it stays in the punch mark, and then increase in size from there.
Personally if the piece doesn't come out with a hole and a easy out, I'll use a small carbide burr to eat away the material of the piece until I can see the tops of the threads. Once I see the threads I'll use a punch I ground special to pick the remainder out. Hope yours doesn't get to this point because it's a royal PITA to do this way. Good luck.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An AC Model M Crawler - by Anthony West. Neil Atkins is a man in his late thirties, a mild and patient character who talks fondly of his farming heritage. He farms around a hundred and fifty acres of arable land, in a village called Southam, located just outside Leamington Spa in Warwickshire. The soil is a rich dark brown and is well looked after. unlike some areas in the midlands it is also fairly flat, broken only by hedgerows and the occasional valley and brook. A copse of wildbreaking silver birch and oak trees surround the top si
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
