Posted by bison on March 10, 2013 at 22:40:00 from (69.168.144.136):
In Reply to: OT - Milking by Hand posted by Hal/ Eastern WA on March 10, 2013 at 15:06:25:
Quoting Removed, click Modern View to seeThat ain't milk no more, You may as wel drink water
I grew up in Europe,We milked 24 cows .My dad used to buy fresh milkcows with an issue on the stockyards just because they were cheap and milk and fatten them up at the same time,by the time they went down in milk production they were fat and sold to a butcher.
More often than not these cows he brought home were 3 teaters and or a teat that was stepped on ,or cows and heifers with very large or really small teats and lots of edema in the udder(one could only milk the latter between thumb and first finger) Some of them could kick like a mule,some kicked so high they knocked a hole in the barn ceiling.
It took at times 3 of us to milk one of these rascals,but with hobbles on, a bullring with a rope in the nose stretched across the feed isle and a pitchfork against the side to prevent the critter from dropping itself on the milker we usually could get them more or less to coperate till they after a few sessions admitted defeat and behave.It sure made wildcow milking on a rodeo here a rather tame affair.
I don't think after all the experience i gathered over the years there isn't a cow born i can't milk.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
