I had a '74 or '79, forget which diesel, with cab. Only problem with it was a clogged radiator. Bought it with 3900 orig. hours and cosmetically completely restored. Engine didn't have a wrench on it.
Mine was somewhat hard to start in the winter till I redid the battery hookup. Rather than run 2ea 6v batteries in SERIES with ground on the right side of the block and the starter on the left, not one of mother Deere's better designs, and as I recall running 1/0 wire, I rewired it.
I put in two 12v series 31 OTR truck batteries of 900 cca each, 3/8 stud terminals and wired them in PARALLEL with 2/0 copper wire. It meant running two big wires under the cab over to the right side to catch that battery, but so what!
With my wiring the batteries were in parallel, which reduced that series resistance to 1/4 what it was as far as the starting current loop was concerned. Then I wired the left battery plus directly to the starter solenoid and the neg to one of the bolts holding the starter to the block both with about 1 1/2 ft. of 2/0 each. Everything was clean, shiny, and tight.
Forget cold weather. That sucker spun up so fast that you had to worry about blowing out the tires on the down side. Ha! Naw not really , but I never touched an ether can again.
I don't know what you call it but I had the shift lever that you could toggle between two adjacent gears in the same range. Worked neat as I could run the row in the higher gear, pop the shift lever to the lower in the turn, and coming out pop it back to the higher gear.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.