Crankshaft end play on an H is adjusted by sliding the flywheel in on the crankshaft. Since the R.H. end of the crankshaft is not accessible, you will have to remove the engine cover and slide the crankshaft to the left while sliding the flywheel in. You may need to use some kind of pry bar through the opening in the main case to push the crankshaft to the left. Since the clutch is on the camshaft there can be several sources of noise. The L.H. camshaft bearing , the R.H. camshaft bearing, or the clutch bearing itself may be causing the problem. Also governor bearings can transmit noise too. When you disassemble the clutch be sure to punch mark the location of the shaft and components so you can easily re-assemble them in the correct position. The same is true of the camshaft and cam gear which is splined to the camshaft if you have to go that far.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
