Posted by Old Harv on April 22, 2013 at 06:43:56 from (184.151.114.168):
In Reply to: Lamb castrating? posted by jon f mn on April 21, 2013 at 20:27:19:
I have been using rubber bands to castrate and dock tails on lambs for 15 years. In that time I have lost two or three to infection in the tails and zero from castrating. I dock and castrate about 500 lambs per year. The infection in the tails happened when the temperature was about 80 degrees or higher. Worrying about a sheep in pain is stupid seeing as a sheep has about 2 brain cells, and those brain cells are scared of each other. Sheep endure incredible amounts of pain. If a horse gets a 2 inch scratch from barb wire it acts in a lot of pain, but I have seen sheep with maggots in their feet and wool eating them alive, and the sheep keeps eating as if nothing was wrong. No brain, no pain. Sure, when you put a ring on a sheep it acts like it is dying for a few minutes. Ever castrated a pig? They scream non stop for about 5 minutes without breathing in and then sit their newly cut behind down in the manure with their back legs spread out and run with their front legs, getting as much salty manure into the cut as possible, and they live to. No one ever promised me a pain free existence, I don't see why my animals should expect a pain free existence.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
