I am an auto tech and have literally performed 100's of retrofits over the years. Here is what you need to do....
1. evacuate the system
2. pull a vacumn to "boil" off any residual moisture
3. charge retrofit oil, most kits will use ester oil as it is compatible with both R12 and R134a oil
4. charge refrigerant to 80% of the R12 capacity.
That is it.....Done. No need to flush as the R134a won't "carry" the R12 oil so it just sits in the bottom of the system, that is why you need to add retrofit oil, it is also part of the reason you only charge to 80% capacity, the old oil is taking up some of the capacity.
When we first started doing these there where a lot of myths around about having to change lines and compressors and anything else you can think of, it is just false. the only real difference in the two systems is the oil, the seals and hoses are all made of the same material.
I will however say that it would not be a bad idea to change the receiver/drier or accumulator (whichever your system uses) This part contains a dessicant to absorb moisture, If the system has been flat or open for any length of time the dessicant is most likely saturated and can no longer do it's job. This however has nothing to do with the retrofit, just a good preventative measure on a system that has been idle for a long time.
Hope this was helpful, sorry for being long winded
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Brief History of Tractors in Australia - by Bob Kavanagh. After Captain Cook's exploration of the east coast in 1770 the British Government decided to establish a penal colony in Australia. The first fleet arrived in 1788 and consisted mainly of convicts who were poorly equipped and new little of farming techniques. The colony remained far from self-supporting and it was not until the early 1800's that things started to improve. Free settlers started to arrive, they followed the explorers across the mountains and where land was suitable set up farms. T
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.