It's OT just the homeowners... the "pros" can behave badly, as well!
My house was built in 1981 and we've been in it for about 12 years, The previous owner had electric baseboards installed (by a licensed electrician) and set up for off-peak heating to supplement the oil-fired hot water heating system, which required snaking some wiring through various walls, etc..
Recently, I snaked some TV co-ox and ethernet cable to several rooms.
As I drilled through one wall, I felt a sickening grab and pull and pretty much knew I had snagged a wire. Cut it in two, actually.
Turned out to be the wire between a wall switch and some ceiling "pot lights" that were not "on" at the time.
I devised a plan to access the wire at both sides of the break and get it into boxes to properly splice it. I cut the wire and the damaged piece didn't want to pull out of the wall. When it finally came out, it was wrapped in a big wad of tape!
Turns out there was a wire to an electric baseboard nearby and when the pros had installed it they hit the wire within a foot of where I did and simply taped it up and stuffed it buck into the wall! I'm GUESSING the young guy on the team didn't want to 'fess up to the damage and suffer the boss's wrath so he taped it and hid his mistake!
Here's a picture of the wire with the outer wad of tape removed...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
