The Jointer/Skimmer mounting arm is clamped into a saddle bracket . The saddle bracket bolts onto the two holes on the rolling coulter frame that I always wondered what they were there for. The saddle bracket"s top clamp has a protruding ridge cast into it"s bore. The shank has a corresponding receiver groove . The top cap clamp will rock on it"s axis depending on the bolt lengths when tightened. As the cap rocks it swings the skimmer/Jointer shank to adjust the blade"s position next to the coulter. The 70D standard that Dad had also bought new , traded and then we located and restored. It has the Complete DA 898 A Landing Lever for side hills. The landing lever requires swinging farther to make up for the extra side travel the clevis allows. Granted if on level ground and if the plough was properly set. It should plough straight and level even if the drawbar was replaced with a chain. With no side loading onto the tractor .
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.