Posted by Paul from MI on June 13, 2013 at 04:21:51 from (204.106.248.120):
In Reply to: sickle bar length? posted by Ralphwd45 on June 13, 2013 at 00:11:04:
I used a 7ft. IHC #27V mower attached to my JD H for 20 years. It was a good combination in alfalfa and would run all day on 2qts. of gas an hour. There used to be an after-market attachment to hold the cutter bar off the ground for clipping weeds in pastures. It was made with a couple of lawn mower wheels and clamped to the back side of the cutter bar, but I haven't seen one in many years. Setting the cutter bar up a bit would work fine if your hay was standing good, but if it has been blown over, not so much. And I would think you'd need something in the center of the bar to compensate for sagging.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.