Posted by JD Seller on June 25, 2013 at 08:49:18 from (208.126.196.144):
In Reply to: Cattle working setup posted by Sparktrician on June 25, 2013 at 08:28:41:
Quoting Removed, click Modern View to see
One when you go to shut the gate the cattle behind will have their head in the way. Two You will not get them all the way shut and have a big cow or steer run through it and it will be bent and stuck half way closed/open.
Do you load cattle through your rear slide door on the cattle trailer??? It is a real pain when you get down to the last few head and are in close quarters.
The automatic type are just as cheap to make and work while your behind the cattle. The object is to keep the cattle moving forward. Not have them in individual pens. At least that is what I want at the chute.
If you want to separate some just put some holes in your chute's side walls for cross bars to be stuck through.
Also 10 foot is about the right length for all cattle. For steers and calves 9 will work but full size cow it takes 10.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Museum Coverage: The Stuttgart Agricultural Museum - by Cindy Ladage. While cold wind was blowing back in Illinois, in Arkansas, daffodils were in bloom, and the Magnolia trees were adorned with fragrant blossoms. Stuttgart, Arkansas was the site of this year's winter Minneapolis Moline Collector's show February 25-27, 1999. The show was held at the Oliver Museum created by Don Oliver, the pioneer of the four wheel drive tractor. Oliver along with Gale Stroh and Kenneth Bull using Minneapolis Moline tractors and parts created what has become known as
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.