Posted by Mel in SW Iowa on June 25, 2013 at 12:00:37 from (75.105.35.227):
In Reply to: Cattle working setup posted by Sparktrician on June 25, 2013 at 08:00:21:
The side and top "no-backs" I have used are similar to JD's pics. If the width of the walkup is adjustable, the "no backs" will sometimes work without adjustment, sometimes will also require adjustment for different sizes and weights. Once a set of cattle have been worked two or three times, "no-backs" work pretty well. Most of the time, I have latched them out of the way for calves. I have also seen a top hung "no-back" made out of 1/4" or 5/16" chain that worked very well on yearlings or larger plus its easier for someone to jump in the alley and crowd calves without injuring themselves on pipe "no-backs".
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
