I have seen rear wheel bearings burn up because no lube in hub, Always fill the hub and wipe little lube on the seal just before sliding on the axle. Also I always use a torque wrench tighten the nuts and preload them turning the wheel then back off and re torque the axle nuts. Big trucks and trailers was pre load to 100lbs back off and retighten to 50 loosen little so lock lines up. Never had one fail but have seen others over tighten the axle nuts and it takes out the bearing. Another thing the bearing companies said was not to wash your bearing unless you get it dirty. They had us wrap then in a shop rag after looking to see if they were not worn to keep the blowing sand or dirt off them. Worked for a major truck barn for over 30 years doing it. I'm sure other people have their way of doing it, but just sharing something I had learn years ago that works for me.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An AC Model M Crawler - by Anthony West. Neil Atkins is a man in his late thirties, a mild and patient character who talks fondly of his farming heritage. He farms around a hundred and fifty acres of arable land, in a village called Southam, located just outside Leamington Spa in Warwickshire. The soil is a rich dark brown and is well looked after. unlike some areas in the midlands it is also fairly flat, broken only by hedgerows and the occasional valley and brook. A copse of wildbreaking silver birch and oak trees surround the top si
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
