The radius of the bales fits down behind the angle iron on the end of each bale spot. The cross pieces are 3 ft apart. A normal 6 foot bale will set down behind the angle iron 8-10 inches. That should hold it much better than the cross pieces being angled up.
I will let you know after we use it for awhile.
I wanted to be able to slide the bales on the cross pieces. When loading this type of wagon you set the first bales in the middle. Then as you put the second bale on you push the center bale out to the side with the bale you are loading. On the slopes we have if you try to load the bales on the sides it will tip the wagon up.
You can also load large square bales on this too.
I had a factory bale mover that had the cross pieces bent up to hold the bales. It did not have any ends on the bars and it was only 8 1/2 feet wide. So the bales had to hang off the ends. That mover was a PIA to use and after just one year of use the cross pieces broke where they had been bent.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An AC Model M Crawler - by Anthony West. Neil Atkins is a man in his late thirties, a mild and patient character who talks fondly of his farming heritage. He farms around a hundred and fifty acres of arable land, in a village called Southam, located just outside Leamington Spa in Warwickshire. The soil is a rich dark brown and is well looked after. unlike some areas in the midlands it is also fairly flat, broken only by hedgerows and the occasional valley and brook. A copse of wildbreaking silver birch and oak trees surround the top si
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
