Posted by Billy NY on July 28, 2013 at 06:06:18 from (72.226.79.200):
In Reply to: Chainsaw Help posted by fergienewbee on July 28, 2013 at 03:41:21:
What Dan said, is the usual cold start procedure.
I'm thinking you have a bad fuel line, my 390 would run, cut out and do odd things, but it ran enough to use, it. I took a deeper look, fuel line for sure, so I took it all apart, and that was not really a big deal, I am trying to remember the tools, I think it was a torx, or a metric socket. The fuel line was fractured in many places, so it was replaced and it does run well now. One thing I do not like on it is the sparkplug wire, the hardware use in it to clip to the plug and contact the wire, is odd in my opinion, its a sharp, spring steel stiff wire, but its pinned through the wire to make contact, I think its the cause of problems at times too, this saw while a fine saw to have, has had issues at times, fuel or I believe spark and could be a hard starter when warm, I have flooded it by over pulling before when cooled, but still warm. The 290 is not much different, mine is an '02 model year saw.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
