Posted by OldBuzzard on August 02, 2013 at 03:42:49 from (50.51.7.19):
In Reply to: Shooting posted by GordoSD on August 01, 2013 at 21:33:12:
I shot .22 cal. 50' indoor in high school from 1961-1964. We competed in a league with a number of other high schools.
I was in the Ohio Soldiers and Sailors Orphans Home in Xenia, Ohio, and since we were a State run institution, it was mandatory that we had Jr. ROTC, and EVERYONE was required to have firearms training. After that, if you were good enough, you could join the Rifle Team.
The US Army furnished the ammo, and some of the rifles. When I first started, the Army supplied rifles were Springfield M2s that were virtually identical to the '03 Springfield but in .22 Cal. Those were eventually replaced with Remington 513Ts.
We also have some Winchester Model 52Bs which is what I used. We always used the same rifle as long as we were on the team, and still I remember it's serial number as I was/am an airplane nut as well: 70707B
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
