Posted by Chip812 on August 09, 2013 at 11:31:52 from (216.226.180.3):
In Reply to: To cut the hay or not? posted by picassomcp on August 09, 2013 at 11:15:51:
You, with your 3 years of experience, have vastly more experience than I do... However, I'm going to post a comment. Not because I have any particular knowledge, but to maybe spark a continued dialogue that may prove educational. Here goes:
It would seem to me that the inputs into the hay would need to be considered as well as the timing. Your time, wear/tear on equipment, and fuel costs are 'fixed'; i.e. the same every time you cut. Seems to me that you should wait and only do one more harvest to maximize your profits.
There, I said it. Now to see if there is agreement or disagreement.
Edit: I can already tell it is way more complicated than I had anticipated.
This post was edited by Chip812 at 11:33:50 08/09/13.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
