Posted by JD Seller on August 28, 2013 at 21:02:42 from (208.126.196.144):
In Reply to: Picking corn today posted by RBnSC on August 28, 2013 at 20:34:32:
How is the corn yielding?? I am hearing of ear rot issues in the south. I have talked to some friends in TX and they are having a record harvest. North and South Carolina too wet
As for the texting. My brother was doing that last fall. HE ran a BIG rock into his combine. Wiped out the front half of the rotor on a JD 9670 combine. It cost him about $4500 and three days of work. I told him to leave the darn phone at home the next time. LOL
Before guys start telling me you can't get a rock into a JD rotor. You can if it is a flat ledge rock about 18 inches in diameter. Went right up the feeder house and the crop accelerator throw it right into the rotor. He was running corn too so the rock trap was full of ears.
It tore out the first two rows of rotor segments and the concave. It messed up the mounting holes in the rotor too. They make a weld in insert that replaced the mounting hole.
We did pull the complete rotor after season and had it rebalanced.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
