The memories are still coming back, the first yr I worked the field as a chopper we had a sort of a hatchet you chopped the plant off close to the ground and handed it to a kid on the wagon just like the ones in the picture he would hang the plant upside down on a wooden lathe that was about 3 ft long and held about 6 or more plants on each side on sharp metal hooks. Once the wagon was full it went to the barn where kids would hang the lathes on tears, the highest tear in the barn was right up in the peak called the perl tear, the older kids got to hang perl tear each tear got more money.They heated the barns with gas heaters and would open the sides as neaded to ventilate.The farmers would come right into the school and set up a table and hire the kids, you needed to be 13 yrs old and get working papers signed by your parents. there would be several farms there so you had your choise Hass and Hathaway come to mind as two farms.Often when hanging plants on the lathes the metal hook would come loose I remember one young kid put a hook in his pocket when he sat down for lunch he drove the point right into his you no what the farmers wife had to take him to the Dr. BTW. Shade grown you harvest only the leaf and it was sown on to the lathes by the girls and hung up by the boys and usualy Jamaicans would work under the nets. I never did make perl tear only got up about 3 tears high as I recall. Thats my memories best as I can tell it and im stickin to it
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
