Posted by mharg on September 09, 2013 at 18:32:13 from (98.184.182.153):
I replaced some hydraulic lines to the control valve. I removed the backhoe from the tractor, replaced lines, and serviced swing cylinders. I have the hoe back on the tractor, and noticed I have the boom lines connected to the 3rd control lever. The bucket lines are on the 2nd control lever.
I have not started the tractor up yet, I serviced all cylinders. I was going to start the tractor up so I could move the boom arm so I could line up the other cylinders on the pin holes.
Will it make a difference, which levers go to each cylinder?
I have never worked a backhoe so I don't care if I switch these controls back right.
These lines are difficult to remove. It also has been extremely hot outside as the tractor is in the sun most of the day.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
