I am also no expert on the newer stuff, but doesn't the voltage regulator (internal or external, doesn't matter) also do current regulation? I have revived many "bad" mechanical regulators and there are three coils, the cutout to isolate the battery when the genny is not putting out, the voltage regulator coil which sets max voltage, and the third is the current regulator coil to limit max current. I would thing a modern alternator would do the same to protect itself. The standard cranking battery could be very low from leaving the lights on, but still be able to start the motor, and would have a high initial draw when charging.
I agree that the more load put on the alternator could cause it to fail sooner. More current, more heat in the diodes, and more brush wear.
If it was my RV, I would get the largest output alternator I could and install an isolator and do away with any manual switching. If possible, wire the voltage sense for the regulator to the main battery side of the isolator so the alternator puts out a slightly higher voltage to make up for the diode drop in the isolator. I had a Ford truck setup with a 140 amp alternator, internally regulated with an external sense, with the second battery to run my ham radio stuff. Worked really well. I had a solenoid wired so I could crank off the second battery, a deep cycle type.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.