Posted by JD Seller on September 22, 2013 at 20:55:17 from (208.126.196.144):
In Reply to: Engine knock, Ford 660 posted by davisford on September 22, 2013 at 18:56:15:
I would drop the oil pan. You can see real fast if something is out of sink there. These little Ford engines are not too expensive to overhaul if you do not have to have the crankshaft ground.
When they where being used for serious farm work it was not uncommon for them to be overhauled every 3-4 years. The rod and main bearings would be worn pretty bad.
Used to see a fair number of them with holes in the blocks because of worn rod bearings. They would get worn where the rod was lose. The the stead slap when running would pop the rod cap off and then the next turn the crank would knock the rod through the side of the block. Many times you could patch the block and rebuild it and drive on. The hole many times was not in the water or oil half of the block or even in any of the main webs if it.
SO I would drop the pan and check the rods and main bearings out first. The reason being that running it even just few more minute may ruin the crankshaft or block. Right now you may be able to just do an in frame overhaul if the crankshaft is not worn too bad. This can be done just about anywhere.
Years ago my Neighbors farmed with six of the Ford 4 cylinder gas tractors. They would do their own overhauls in a dirt floored shed. They had a stove in there and would work on them in the winter. One spring they had one go down unexpectedly in the spring. They did an in frame overhaul in under 6 hours with two of them working. That was new sleaves, pistons, rods and main bearings, and the valves/guides replaced.
So check it out. Even with just modest mechanical abilities you can overhaul one.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An AC Model M Crawler - by Anthony West. Neil Atkins is a man in his late thirties, a mild and patient character who talks fondly of his farming heritage. He farms around a hundred and fifty acres of arable land, in a village called Southam, located just outside Leamington Spa in Warwickshire. The soil is a rich dark brown and is well looked after. unlike some areas in the midlands it is also fairly flat, broken only by hedgerows and the occasional valley and brook. A copse of wildbreaking silver birch and oak trees surround the top si
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
