green horn476 said: (quoted from post at 17:26:27 10/06/13) I have a feeling I am not engaging properly as you stated. If motor needs to be running when engaging PTO that is most
likely my problem. I know that the PTO handle didn't seem to want to move freely, but the motor wasn't running at that point?
Yes have motor running (idle or just enough throttle to gently spin your implement without killing tractor). Push foot clutch in. Fully engage PTO lever. Slowly release foot clutch. (makes no difference if you have tranny in Nuetral or a forward gear or reverse gear). Throttle up to desired implement speed from here.
Important Note: Your tractor does not have live or independent PTO. In other words every time you push foot clutch in to stop so will the PTO as the same engine shaft that drives your tranny drives your PTO - or in other words the tranny and the PTO are tied together. In many cases implements (like a bushog or a baler) can cause a flywheeling effect and continue pushing you forward into a fence, building, tree, ditch, etc. through the PTO backfeeding the tranny when you try to stop by pushing the clutch in. Even though you have the clutch pushed in the spinning PTO will continue pushing you in whatever direction you were previously traveling in a very herky jerky fashion until that stored up energy remaining in the spinning implement is extinguished. A $50 to $60 PTO external overrunning clutch is a very wise purchase to make and will prevent the PTO backfeeding the tranny and greatly enhance your safety. These are available from TSC, local dealer, even the internet. With one of these overrunning clutches, you can stop immediately and you will simply hear a ratchet clicking sound of the one way overrunning clutch doing its job for you. (remember to keep the external overrun clutch greased).
This post was edited by rankrank1 at 09:59:42 10/06/13 4 times.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.