Posted by dr sportster on November 21, 2013 at 10:31:15 from (68.195.44.8):
In Reply to: What the heck?? posted by Goose on November 20, 2013 at 16:26:52:
The wire does not go bad by itself. Something has to damage it. If you are testing correctly [best way would be to take the leads off the lugs ,bug them together then go to the other end and place the continuity light on that side , eliminating any connection problems like no penetrox oxidized ends etc.. If you have no continuity then the wire was possibly damaged during the pull and a small insulation nick which is laying in muddy water has bubbled enough to eat itself up. Could be someone stepped on it and a sharp rock was under it or the pipe edge scraped it or the handling from the supply house. But somewhere the insulation got breached and once you pull it back out you will see the problem. .All pipes get filled with water that I have ever seen. It is called tracking and it has to do with ions.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
