Yup , center bearing. IH tractors use very similar starter,(along with a lot of other machines) and some have center bearings and some don't. The smaller tractors like a Farmall C did not use one and I have seen starters on H Farmalls that did not. Some times the drive end housing is machined and holes with tapped threads for the bearing, and some are not. I installed a lot of them over the years and it really helps those 6 volt grunting starters. When you throw the juice to that starter the magnetic fields push and pull that armature toward the pole shoes. If the armature touch's or even gets closer it affects the torque delivered by starter. I have been around a few WC's and know they never had an extra lively starter either so I think a center bearing would be good for that starter. Also, a lot of the commentator end frames do not have replaceable bushings in them and a center bearing will support that armature much better even if that end is worn. Those end frames are expensive to replace if worn and no bushings in them.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An AC Model M Crawler - by Anthony West. Neil Atkins is a man in his late thirties, a mild and patient character who talks fondly of his farming heritage. He farms around a hundred and fifty acres of arable land, in a village called Southam, located just outside Leamington Spa in Warwickshire. The soil is a rich dark brown and is well looked after. unlike some areas in the midlands it is also fairly flat, broken only by hedgerows and the occasional valley and brook. A copse of wildbreaking silver birch and oak trees surround the top si
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
