Posted by ShadetreeRet on December 09, 2013 at 22:04:44 from (76.3.100.234):
In Reply to: Frankentractors posted by DeltaRed on December 09, 2013 at 21:34:59:
Steve, You are so right about the ingenuity of the American farmer! Were it not for this ingenuity, we would likely not have a lot of the modern equipment today. And what amazes me to no end, is the fact that those who invented/developed so much of this equipment did so without computers, without CAD, and all the other modernistical stuff. They did it with just an idea, simple logic, and a pencil and slide rule when needed. I remember when I was in my late teens, Dad had a VAC Case and wanted a wide front axle, so he used the front axle from an old two-ton Chevy truck and and after careful measurement, had a mounting bracket welded up. When we got everything together, you turned the steering wheel to the right, the wheels turned to the left! Had I only known then, what I know now, it would have been an easy fix, but as it was, Dad deemed the project a failure and continued to use the narrow front end.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
