Posted by John T on December 20, 2013 at 05:42:02 from (216.249.76.176):
In Reply to: Shop lighting posted by Bob Bancroft on December 20, 2013 at 04:19:15:
While High Intensity Discharge (HID) lights are more efficient (more lumens per watt), their higher initial cost, time delay (absent additional features), potential re strike issues, mounting, extra weight. etc. etc. makes the readily available, relatively cheap, good color rendition (subject to bulbs), easy bulb replacement strip fluorescent fixtures attractive for many shops.
Id go with Fluorescent but that"s not to say depending on the shop design and ceiling height and color and the fixtures used, HID might be a better choice over the long run. A lighting engineer would need all the physical info and your needs before making an informed professional choice.
Its been years n years since I attended General Electrics Lighting Institute at Nela Park, but do recall some basics. The general rule of thumb when computing how may lights/fixtures are required at a given location, is Foot Candles = Lumens X Coefficient of Utilization (CU) / Area. In an office environment with a white low ceiling and reflectors, a CU of 70% + may be attainable as I best recall (NO Warranty Billy Bob so dont have a calf) while a higher dark colored ceiling like in a shop with dark floor the CU would be muchhhhhhhh less.
Things such as a white reflective ceiling and good reflectors improves the CU and while you might (depends on your use and needs) get by with 50 or 60 Foot Candles or less in a shop 100 would be nice, but again the ceiling height and color and reflectors and fixtures used make the difference.
DISCLAIMER this is merely an opinion and like all others here it may be right and it may be wrong, I"m NOT saying if it is or it isn"t, take it or leave it, your choice.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.