Posted by Pops1532 on December 22, 2013 at 15:24:34 from (98.227.133.60):
In Reply to: Pole Shed posted by john in la on December 22, 2013 at 11:23:54:
Quoting Removed, click Modern View to see
Trusses are typically 8, 10 or sometimes 12' on center on pole barns. Since your posts are 8' OC I'd go with trusses 8' OC as well. Notch the posts for the trusses or better yet use laminated posts.
The roof purlins should be on edge not laying flat. You can use joist hangers and butt the purlins against the trusses or you can get brackets that let you run the purlins across the tops of the trusses.
I haven't seen a good 3 tab shingle in many years. You can get very good architectural shingles that will handle the 110 MPH wind. Still, I'd be inclined to use steel with a 45 year or better finish.
I'm not a fan of composite siding so I'd go with steel siding as well.
18" overhang is unusual. Depending on your plans on finishing the overhang, 16" may waste less material.
I wouldn't use the osb and felt under the steel roofing. You'd be money ahead to insulate the roof, or finish the ceiling and insulate it, and make sure the attic has good ventilation.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
