Posted by Chris Jones on January 06, 2014 at 06:30:21 from (24.148.141.137):
In Reply to: PTO chipper posted by Whichester1 on January 06, 2014 at 00:52:41:
I'd like to have one too but really can't justify it. But before I spent any money on a big box store one I'd get a used rental size chipper. Vermeer BC600 or BC625, or Rayco RC6D are all "real" towable chippers with 6" capacity and hydraulic feed. Frankly I sometimes see used larger chippers on Craig's List. I don't want to mess with holding sticks up in the air and pressing them down into a chipper for minutes. I want an infeed table, to push it in and listen to berrrup and push another in. The only ones that scare me a bit are the older "chuck and duck" drum chippers that use the cutting action to pull in the limb--they feed in so quick there isn't time to save you if you sleeve gets caught on the limb. PTO chippers seem to be over priced for their capacity. Sometimes it's cheaper to have a dedicated tool.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
